Can disposable batteries recycle use?

Rechargeable alkaline manganese batteries round 20 times, but this is different from the loading process of secondary battery. Because they can not be a real rechargeable batteries, because under normal circumstances, being the depth of discharge is only part of the landfill. Therefore, charge is only part of the burden in this manner will generally referred to as “renewable” to distinguish it from the secondary Laptop battery real burden. In fact, the limit loads of discharge and short life cycle determines the regeneration of alkaline manganese batteries, when the economy itself.

To ensure the successful regeneration of alkaline manganese batteries, you must meet the following conditions:

1. In the case of moderate discharge rate of the initial capacity of the battery discharge to 30%, while the discharge shall not be less than 0.8V, regeneration is possible. When the discharge capacity of over 30%, the manganese dioxide produced to prevent the further regeneration. 30% of the capacity and discharge voltage of 0.8 V to use the appropriate equipment to control, but most consumers do not have these devices.

2. Users can buy a charger to regenerate. Other shippers, such as nickel, nickel-metal hydride VGP-BPS10 battery charger cadmium rechargeable alkaline manganese can not be used because of their load current is too high may lead to the battery internally generated gas, so gas from the safety valve, the leak would be. If the safety valve useless, or even an explosion (as in the production of molds bad happens very rarely), but it will, especially those who lack the proper use of the battery.

3. Regeneration by the time needed (about 12 hours) is beyond the discharge time (1 hour).

4.20 cycles, VGP-BPS11 battery capacity will be reduced to 50% of the initial capacity of 5 years. A given device, it takes three or more connecting to the battery if the battery capacity is inconsistent, regeneration, then other problems arise, which could lead to the battery voltage into a negative value if regeneration of the battery without the use of batteries will be used together even more dangerous. Battery reversal leads to hydrogen fuel cell generated internally, there is the danger of high voltage generated, resulting in leakage or even explosion.

A long period of time, the recycling of batteries is not only profitable but also risked some danger, to avoid danger, it is best not used with a battery or a rechargeable battery (battery) are not renewable Once the battery.

Seven points to keep in mind about car batteries maintenance

Car battery is important, its function is to provide an electric starter, the engine starting or operating at low speed for the ignition system of motor and other electrical equipment. High-speed operation when the engine when the generator enough, the VGP-BPS8 battery can store excess energy. Unfortunately, it is generally ignored by most people. I do not know the proper maintenance of batteries to keep it plenty of power, is an important part of vehicle maintenance. The following will introduce the conservation of car battery connected to knowledge and common sense, to help you better understands the use and maintenance of the battery to extend battery life.

Car battery car battery works the vast majority of lead acid batteries. In simple terms, it is a chemical energy into electrical energy capable of electrochemical devices. Lead acid battery in the positive and negative plates, bulkheads, shell, etc. electrolyte and wiring trailer hitch and the discharge of chemical reactions depend on the active positive plate (lead dioxide PbO2) and the negative active material (sponge of pure lead, Pb) in the electrolyte (sulfuric acid composition of H2SO4 and H2O water) and as a result. A standard 12V lead-acid VGP-BPS8B battery contains six modules, each of the power of electricity is about 2V (one for each power supply has a positive and negative column: column is entered the positive sign “+”, dark brown negative column when a “-” sign in pale gray).

Traditional batteries will occur in the electrolyte is in decline is because the frame plate door with traditional batteries lead alloy of antimony, antimony will pollute the negative plate of pure lead sponge, weakened after the battery is fully charged in a Counter electromotive force resulting from the decomposition of excess water, a large number of oxygen and hydrogen, respectively, escaped from the positive plate and negative, so the reduction electrolyte.

Without maintenance (maintenance free) batteries into the design principles and traditions of the battery on a coherent strategy, the use of thicker plate materials, important difference is that the plate is consistent with lead calcium alloy. In the electrolysis reaction, it can reduce the flow of excessive burden, reduce the rate of vaporization of liquid, thus reducing the loss of electrolyte, compared to prolong battery life.

Discharge and load

In the year (discharge) process dioxide very edge of lead (positive), the spongy lead (negative), and sulfuric acid electrolyte chemical reaction occurs to produce the discharge of lead sulfate (PbSO 4) and d water (H2O), positive and negative plate the difference between reduced. Because the battery voltage depends on different electrode materials and electrolyte concentration, so the reaction after discharge, the battery loses power. Charging process (charge) and discharge process to the contrary. Current in the generator under the action of sulphate of lead and water lead dioxide (positive), the spongy lead (negative) and sulfuric acid, plates, electrolyte concentration restored, the BATCL50L battery of energy.

Caution

1 to start the car every time startup should not exceed 3-5 seconds after starting interval of at least 10 seconds.

2 vehicles often short driving distance open-window open will result in a prolonged state of battery charge less to shorten the lifespan. On the highway driving at a constant rate of 20? 30 minutes, may give enough time to recharge the battery.

3, driving a day before leaving the car, check and ensure that all lights and other electrical appliances (such as radios, CD) has been closed. Because it may drain your battery.

4, if the battery runs out, to ask the fire (Jump-Start, also known as tie-lines) to begin immediately possible a constant speed (such as highway speed) drive at least 20? 30 minutes to fully charge the VGP-BPS11 battery.

5, in the full discharge of the battery case, ask the fire may be unable to help you start your car. In this case, you must use a dedicated battery charger for slow charging.

6, where cars are not long-term investment should first fully charge the car. At the same time every month, launched his car, operation at medium speed for about 20 minutes. Otherwise, place too long, it would be difficult to start.

7 to understand the life of the battery. Using more than 4 years, the recommended replacement.

Waste batteries repair is necessary

In recent years, people blindly focused on economic development at the expense of environmental protection to the environment have had an undeniable impact. While environmental issues and livelihoods in this regard would be of concern to all the specific details of our lives, on drums, for example, domestic civil society over 20 billion batteries a year, consumption of 6 billion, coupled with other types of cells, their number is very striking. Then we often use VGP-BPS8B battery electric vehicles, many people are not very expensive.

The advent of electric cars and pop will also be the standard with a large number of battery electric vehicles will be used. As the batteries of electric vehicles as a result inevitably bad, then the batteries of electric vehicles is necessary to lay broken VGP-BPS8 Mody? Is this not the case? Reuse of waste batteries will be repaired or if it is the resource for the environment would be very beneficial. Of course, this would undoubtedly promote the formation of piles of the waste industry to repair, and become industry leaders in the industry chain.

Batteries food waste is a high technology, why should we spend the effort to study the batteries Fix It? To return used batteries in the restoration work that we do not want to be as simple as that. Waste batteries need to have a professional repair equipment repair, and repair personnel professional, such a procedure is not telling the truth, like a VGP-BPS10 battery to change it. But from the standpoint of environment and resources is not the case. So how can we understand the specific terms used batteries repair industry? While speaking briefly about restoring the bar normal cell into repair mode.

The repair process of the battery in the operation of wastewater from the battery is over, so that positive and negative aspects of the machine are correct, the machine entered the charge state of repair, repair cycle 10AH is 5-8 hours, and 20Ah need 8-12 hours to get to the battery terminal voltage to 16V or more to stop the repair. Just for the initial discharge time allowed, are renewing a test discharge of the battery can. Then you will find restored before the discharge time much longer than the repair, indicating that the VGP-BPS11 battery has a positive effect repairs, as the ability to reach more than 70% of the plant can be operated.

To determine the reasons for battery plates

In the failure of the vehicle battery, the majority of plate curing, resulting in lower volume starts the engine difficult, if not the ignition, allowing the scrap VGP-BPS10 battery fast. The failure of the early to judge now, the causes of exclusion methods and preventive measures are described below.

1 baking lack of determination

If the car battery, the following phenomena occur, namely that the VGP-BPS11 battery produces sulfide, and should take measures as soon as possible to be eliminated.

1. in the surface of the sheet with a layer of white, hard, but coarse grains (lead sulfate) is sulfide plate.

2. Cooking plate, the VGP-BPS13 battery internal resistance increases, the capacity will be reduced, thus unable to start rotating machinery, the cure if serious, can not cause the engine ignition spark plugs can not work properly, all this shows that the sheet polymerization.

Secondly, why plates sulfide product

1. Battery in a discharged state of permanent or long-term investment without charge in a timely manner, causing an increase in the electrolyte of lead in sulfuric acid, forming a white board in a hard, coarse grain size, but the hotplate.

2. Due to evaporation, decomposition, loss caused by factors such as reduced, no time to add distilled water to make liquid level lower platen and the electrolytic oxidation. The impact of body movements more Kuang exposed electrolyte adhesion plate, a smooth body again after the exposed plates, the electrolyte in the lead sulfate will be fixed in a board very Shen. So Shen is defined, it will form a plate of polymerization.

3. Discharge was too severe, the surface of the VGP-BPL11 battery, dirty, has a serious self-discharge electrolyte often too large a proportion of the state, or impure, may also lead to electrolyte hob.